This happens when these email providers think you’re spamming (sending out a lot of emails) and subsequently block/erase the whole account. My Gmail/Yahoo/Outlook account is blocked.Make to sure to choose the option to treat the sender address as a trusted email address. This is because Gmail/Yahoo/Outlook automatically moves these emails to the Spam/Junk folder. No longer receiving alerts from Hikvision.Common issues with the Email notifications If you see this message than everything is done correctly. You should see the “ Testing Succeeded” message and receive a test email at the receiver’s address. Fill out the settings as shown in this picture. Fill out the settings as shown below (in this demonstration we used Gmail). The sender can be a dummy email just to bounce the email from the camera/NVR to your email.įor this service, you can create an account on Gmail, Yahoo, Outlook or GMX.
One is going to be the sender and the other one the receiver. You need at least two email accounts to make this work. In this step you need to make sure the network settings on the camera/NVR are correct and that the device can connect to the internet and subsequently send the email alerts out.Įt the correct subnet mask, default gateway (of your router) and DNS servers (for these you can use the DNS servers from Google). Configure the network (internet) settings on the NVR or camera Here you can set to receive the alerts on certain time frame. So only during this time frame we will get alerts. In this sample we set the schedule 8AM-8PM. Let’s say you need these alerts only during a certain time frame. On the Arming Schedule you can set the schedule when you need the alerts enabled. Go to Linkage Method to check “Send Email” and to trigger the correct channel. Go to Linkage Method and check the send email option, as shown on the picture below. Make sure the email alerts are turned on and the arming schedule is correct. Enable the Motion, draw the area and set the sensitivity. If you have a recorder, you need to do these settings for each camera. Here you enable motion detection, at the same time you can modify the area you need to be covered and the sensitivity. Go to the Configuration > Event> Basic Event and then Motion tab. Install the plugin if the browser asks you to.
Type the IP address of the device on the url bar of your browser (for example: 192.168.0.200) and login using your username and your password. In this guide, all the settings are done via the web browser (Internet Explorer or Mozilla Firefox, Chrome doesn’t work). You can complete this step directly on the recorder via GUI or through the web browser. The first step consists of enabling motion detection on your Hikvison recorder or IP camera. The procedure is the same for NVRs, DVRs and Hikvision logo or OEM IP cameras. This article with show you how to set up the motion detection email alerts on Hikvision equipment.
0 kommentar(er)
